For an introduction to CVS locks focusing on user-visible behavior, see section Several developers simultaneously attempting to run CVS. The following section is aimed at people who are writing tools which want to access a CVS repository without interfering with other tools acessing the same repository. If you find yourself confused by concepts described here, like read lock, write lock, and deadlock, you might consult the literature on operating systems or databases.
Any file in the repository with a name starting with `#cvs.rfl.' is a read lock. Any file in the repository with a name starting with `#cvs.wfl' is a write lock. Old versions of CVS (before CVS 1.5) also created files with names starting with `#cvs.tfl', but they are not discussed here. The directory `#cvs.lock' serves as a master lock. That is, one must obtain this lock first before creating any of the other locks.
To obtain a readlock, first create the `#cvs.lock' directory. This operation must be atomic (which should be true for creating a directory under most operating systems). If it fails because the directory already existed, wait for a while and try again. After obtaining the `#cvs.lock' lock, create a file whose name is `#cvs.rfl.' followed by information of your choice (for example, hostname and process identification number). Then remove the `#cvs.lock' directory to release the master lock. Then proceed with reading the repository. When you are done, remove the `#cvs.rfl' file to release the read lock.
To obtain a writelock, first create the `#cvs.lock' directory, as with a readlock. Then check that there are no files whose names start with `#cvs.rfl.'. If there are, remove `#cvs.lock', wait for a while, and try again. If there are no readers, then create a file whose name is `#cvs.wfl' followed by information of your choice (for example, hostname and process identification number). Hang on to the `#cvs.lock' lock. Proceed with writing the repository. When you are done, first remove the `#cvs.wfl' file and then the `#cvs.lock' directory. Note that unlike the `#cvs.rfl' file, the `#cvs.wfl' file is just informational; it has no effect on the locking operation beyond what is provided by holding on to the `#cvs.lock' lock itself.
Note that each lock (writelock or readlock) only locks a single directory in the repository, including `Attic' and `CVS' but not including subdirectories which represent other directories under version control. To lock an entire tree, you need to lock each directory (note that if you fail to obtain any lock you need, you must release the whole tree before waiting and trying again, to avoid deadlocks).
Note also that CVS expects writelocks to control access to individual `foo,v' files. RCS has a scheme where the `,foo,' file serves as a lock, but CVS does not implement it and so taking out a CVS writelock is recommended. See the comments at rcs_internal_lockfile in the CVS source code for further discussion/rationale.
Go to the first, previous, next, last section, table of contents.